Skip to content
Big Spring Drywall Repairs
(432) 348-2325Open 7 days, 7am–9pmCall the crew

Service area around Big Spring

Big Spring is home base. It sits where US 87 crosses Interstate 20, near the Permian Basin oil country, and most of our days are spent inside the city limits. We also drive out to the smaller towns listed here. For the farther ones we like to group a few repairs into one trip, so tell us about every wall that needs work when you call.

A textured ceiling with a faint brown line along a seam where the board dips slightly.
Ceiling sag along a seam, the kind of repair that is worth a drive.

Towns on the route

Big Spring

The county seat of Howard County; the 2020 count put the city near 26,100 residents. We work all over town, from the older blocks near downtown to newer streets at the edges, and around Comanche Trail Park and the foot of Scenic Mountain.

Coahoma

A small Howard County town ten miles east on I-20. Close enough that a single patch or one cracked ceiling is worth the drive.

Sand Springs

An unincorporated Howard County community that the interstate runs right through. Many homes here sit on larger lots, and we treat it like part of town for scheduling.

Forsan

About fourteen miles southeast on FM 461. The town grew out of an oil strike in the 1920s and is still tied to the oil field. Small jobs are fine; we try to pair them with other calls on that side of the county.

Stanton

The Martin County seat, west along I-20. We take crack, hole and water-damage work there, usually scheduled as a full-day visit.

Ackerly

A small farm town in cotton country that straddles the Dawson and Martin county line. Best for larger repairs or several rooms at once.

Garden City

The Glasscock County seat, twenty-seven miles south of Big Spring. We book it for bigger jobs, such as a ceiling section or a room of texture.

Not sure if your place is close enough? Send the address or ZIP with your message, and you get a straight yes or no on the drive. A ranch house out past the edge of a town map is usually fine. Use the repair request form, or start with the guide to hole sizes.